Verint Nextiva S1700e Series Uživatelská příručka stáhnout pdf (Strana 20)

2: Configuring and Installing the Device

8 Verint Video Solutions

Configuring the Device

The configuration steps to execute are:

 Assembling the power-over-Ethernet kit (on the PoE

devices only)

 Setting a series of parameters, including the IP address

 Establishing a point-to-point connection between a receiver

and a transmitter, if required

To configure the device, you need the proprietary SConfigurator

tool. It is included on the SmartSight Utilities CD shipped with

your device; you can also find its latest version on the Verint

Video Solutions extranet (Technical Support, then Downloads,

then Firmware Upgrades). You have to copy its executable file

to the hard disk of your computer.

Computer Requirements

The minimum hardware and software requirements for the host

computer needed to configure the edge device are:

 An Ethernet network card

 A serial port (not through a USB converter)

 Internet Explorer 6.0

 Microsoft DirectX 8.1

 Windows 2000 Service Pack 2 or higher, or Windows XP

Service Pack 2

Assembling the PoE Kit

You use the supplied power-over-Ethernet (PoE) kit to power

the S1700e-PoE device and establish the Ethernet connection.

The PoE kit contains two items: an injector and a power cord.

Warning: On a PoE device, never connect an external power

supply in the DC Pwr poles on its back.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 94 95

Žádné komentáře

Verint Nextiva S1700e Series Uživatelská příručka Strana 20